Super Tac Adhesive
Super Tac is a tacky adhesive that is a high strength, formulated for adhering anchors (TPA’s - Jordahl Perforated pins) for hanging insulation. It bonds metal and nylon anchors to metal, concrete or masonry surfaces. Super Tac can be used to install metal or ceramic wall fixtures in tile applications. It is also recommended for use as a general-purpose construction adhesive in applications requiring a high strength bond, or in applications subjected to high temperatures.
Features:
• Excellent thermal shock resistance
• High bond strength
• Water resistant
• Immediate grab
• Mildew resistant
• Non-slip formula
Directions for use:
Use only after careful consideration of the warnings, directions and first aid instructions given. Use only adequate ventilation: Do not breathe dust, vapors or spray mist. Prevent static build-up. Properly bond and ground all containers and components. Vapors may ignite explosively. Keep away from heat, sparks and flame. Do not smoke. Extinguish all flames and pilot lights, and turn off stoves, heaters, electric motors, and other sources of ignition during use and until all vapors are gone.
Surface preparation:
Surfaces to be bonded should be clean, dry and free of any oil, grease, frost or any other foreign matter which will impair adhesive. Do not use over painted surfaces. Clean all metal surfaces with methylene chloride, acetone or other degreaser, exercising safe practices as recommended by the manufacturer. Some protective coatings are not compatible with Super Tac adhesive. Make a test bond before proceeding with application.
Adhesive preparation:
Super Tac adhesive should be stored at room temperature (60° F to 80°F) for at least 24 hours prior to use.
Working temperature:
For best results, adhesive and materials to be bonded should be 30° F to 120°F.
Application:
Prepare and install one anchor at a time. Apply a dab (the size of a small walnut) of Super Tac adhesive to the anchor base with a putty knife and immediately (maximum open time is 15 minutes) press anchor firmly into place, with a slight twisting motion. For proper adhesion, insure that the film of adhesive covering the anchor base (after the anchor has been firmly pressed into place) is approximately 1/16” thick and protruding through the perforated base plate. Application will be 95% dry after 48-72 hours at 75ºF and 50% relative humidity. Do not apply load until application is completely dry.
Installing metal or ceramix wall fixtures or tile:
Butter the back with Super Tac adhesive and immediately press in place with a slight twisting motion. Allow to dry 24-72 hours before subjecting to use.
Installing Adhesive to concrete:
New concrete surfaces need to cure a minimum of 28 days in order to ensure best adhesion. All concrete surfaces should be higher-pressure water- or sand-blasted to remove any surface curing agents and all foreign matter. Spread Super Tac adhesive allowing solvent to flash off for several minutes before pressing anchor firmly into place. Do not apply load until application is completely dry.
Drying:
Applications will be 95% dry after 48-72 hours, at 75ºF and 50% relative humidity. Heat and humidity, or cold weather can cause longer drying times.
Clean up:
Mineral spirits, exercising safe practices.
Storage:
Replace lid after each use and secure tightly for storage. Store out of direct sunlight in a cool, well-ventilated area. Avoid storing container directly on the floor or against an outside wall.
Warning:
Please review the Safety Data Sheet
Super Tac 22-15 Zero VOC available for California
KEEP OUT OF REACH OF CHILDREN
FOR PROFESSIONAL OR INDUSTRIAL USE ONLY
SALE TO CONSUMER IS IN VIOLATION OF FEDERAL LAW
